Hp Envy 7645 User Manual (2024)

FAQs

How do I connect my HP Envy 7645 to my computer? ›

Turn on the printer, and then connect the USB cable to the printer and to the computer port. If a Found new hardware message displays, follow any prompts to install the printer. If you can print, the driver installed successfully. If you cannot print, continue with these steps to add the printer in Windows settings.

Restart your computer or mobile device, printer, and router to clear any error states. Disconnect your computer or mobile device from the network name (SSID), and then reconnect it to the same network name your printer is connected to. If the printer is available and has a ready status, the issue is resolved.

Your printer should have been packaged with a USB cable regardless of whether it is a wireless or wired printer. Plug the cable into your printer and your computer's USB port. The direct linking should trigger your computer to recognize the printer and start up the software needed to complete the installation.

Press and hold the Wireless button and the Cancel button for five seconds. Wait for the printer to restart and for the Wireless light to blink. Within two hours, return to the app or software to find and add your printer and complete the setup.

To set up a printer for the first time, remove the printer from the box, connect the power cord, add printer to HP Smart, load paper, install the ink cartridges, and then align the printer. Note: If you are looking for the printer software, go to 123.hp.com.

The HP Smart app is the main software for your printer. Install it on the device you want to print from, and then use it to set up the printer connection.

How to set up internet on HP printer? ›

Click Network > Wireless > Wireless Setup Wizard > Next. Select the name of your Wi-Fi network, and then enter the network password. The printer connects to the Wi-Fi network, and the Wireless light stops blinking. If you are using a Virtual Private Network (VPN) connection, disconnect the VPN.

To run the test, turn on the printer while holding down the LF/FF button or Load/Eject button. Self test is printed in Draft characters when the LF/FF button is held, or in NLQ characters when the Load/Eject button is held. When using single-sheet paper, load paper in the printer.

Connect the power cord to the rear of the printer, and then connect the other end of the cord to the electrical outlet. Press the Power button to turn on the printer.

Printers with built-in Bluetooth

Turn on the Bluetooth radio on the printer. Depending on the model, press the Bluetooth button , or navigate to the Setup or Network menu to access Bluetooth settings. Open the Bluetooth settings on the computer or mobile device, and then confirm the feature is turned on.